Products Categories
Contact Us
  • Add:No.16 Jiuyuan Road, Automobile Industrial Zone, Economic Development Area, Jiujiang City, Jiangxi Province, China

  • Mob:+8615949585167

  • WhatsApp:+8615949585167



Main Points Of The Process Of The Lamp Rod
Nov 26, 2018

1.before cutting first adjust the slope of the cutting machine and the required longitudinal scissors ruler.

2.set the position of the steel plate, to ensure the maximum size of the residual material, so that the residual material can be utilized. 

3.the length of the size from the opening of the usual guarantee, wide bottom size requirements ≤±2mm high rod under the size tolerance of each rod head to take positive tolerances; general: 0-2m.

The small head takes negative tolerances, the -2-0mm size adjustment is good, by the cutting machine, automatic cutting machine to complete. 

4.Equipment: The material should check the operation of the rolling shear equipment, remove debris on the track, to maintain a good operating state of the equipment.

Related News

24 hours at your service:

Contact Us